Sunday, July 26, 2015

complete parts list



This is the complete parts list in order to build this frame (just the frame not the full multirotor)
1 x Dozer 260 bottom plate
2 x Dozer 260 arm
1 x Dozer 260 top battery plate
1 x Dozer 260 top vtx plate
1 x Dozer 260 clean section plate
1 x Dozer 260 FPV camera case (optional, for users with fpv board cam like me)

1 x Set of nylon spacers 20mm (tapped)
1 x Set of nylon spacers 20mm (threaded)
1 x Set of Vibration Dampening Balls

4 x M3 x 30mm screw + nut
12 x M3 x 6mm screw
2 x M3 x 6mm screw + nut OR epoxy glue (depending on how you prefer to mount the fpv camera case)


Minimal tools you need to build this frame:
- 30cm measuring stick.
- pencil.
- hand saw (for cutting metal)
- screwdriver to fasten the M3 nuts
- handrill with 3mm and 7mm drill (for drilling metal)
- 1.5mm carbon fiber sheets to cut out the different plates.
- 15mm square aluminum tube to cut out the different arms.
- copper wire & lipo battery plugs


The next list are the parts I used to make a complete flying fpv race quad copter
4 x DYS 1806-2300kv brushless motor
2 x Gemfan 5030 Multirotor ABS Propellers CCW & CW set
4 x HK Blueseries 12 brushless speed controller
1 x MultiWii 328P Flight Controller
1 x RC receiver (depending on the RC system you use)
1 x Sony 700TVL CDD camera
1 x Immersion 25mw video transmitter
1 x HK on screen display
1 x ImmersionRC 5.8GHz Circular Polarized SpiroNet Antenna V2
1 x Turnigy nano-tech 1800mah 3S 65~130C Lipo Pack





No comments:

Post a Comment